Getting ready for tech inspection

Finished up fitting the A-pillar trim, wet sanded and polished the black windshield header panel, and reinstalled the weather strip.

Padded the roll cage, everywhere a helmet (or bare head) might hit it. The most likely contact spots use dual-durometer padding, so it’s softish if I hit it climbing in and out of the car (or in a fender bender on the street), but has a high density core so it does something in a crash with a helmet. Added a new GPR760 sticker.

Click the image to open in full size.

Finished wiring and plumbing the Aquamist HFS-3 and Howerton custom fuel cell. Ran through the startup / test procedure, no problems. Filled with meth and ready to run.

Swapped out my drivers side mirror housing for a spare (the old one was kinda floppy).

Wired the harness for my trailer lights.

Swapped my Necksgen latches from my old SA2005 helmet, onto my new helmet.

Cleaned things up a bit. Ready to go for track inspection tomorrow. Might play with my front ride height in the morning before I go, if I have time. Safelite is supposed to come out tomorrow afternoon and install a new windshield. Car will be looking good after that…